contact@xinephvinyls.co.uk


Visit Our Ebay Shop

 



Each decal comes in three pieces:

1. The top layer is the application tape.
2. The middle layer is the vinyl decal.
3. The bottom layer is the backing paper.


The application tape is only suitable for a dry application.

These instructions are meant as a guide only.
Other ways to apply include taping the decal in place with masking tape before removing backing paper

Clean the surface
Use a dry cloth to clean the surface of any dirt or dust
Remove backing paper
Using a squeegee or credit card run over the sticker making sure all parts are fully attached to the application tape. Then remove the backing paper
Placing the sticker
Once the sticker is ready to be applied, make sure it is aligned correctly and stick down one side of the application tape to keep it in place. Using a squeegee or credit card start to apply pressure and work your way across, evenly forcing the air from beneath the vinyl.
Removing application tape
When removing the application tape, always pull it slowly, back onto itself, at a 180 degree angle. Bubbles should be punctured using a pin.
Page 1 of 1 Page: